There are three families of Manual Elevated Monitors.

• 103561 Series Freestanding ( unsupported ) up to 22'
• 103377 Series Freestanding ( unsupported ) From 22' to 42'
• 102999 Series Supported up to 150'

In each of these families you have three monitor sizes available. The 2.50" version is the dash 1 (-1) series aka BB series. The 3.00" is a dash 11 (-11) or C series. The 4.00" rounds out the set with dash 21 (-21) or D series. The last dash number is the height in feet in 1 foot increments. The height of an elevated monitor is measured from the bottom of the flange to the outlet @ horizontal. Please keep in mind the height of the intake base & foundation when determining the required height above grade.

--------------------------------------

While not mandatory, Stang does recommend the use of a normally closed gear operated butterfly valve at the inlet of the intake base and a normally open flanged gate valve prior. The gate valve allows for system maintance. See image here.

--------------------------------------

Some configurations are not available on elevated monitors. Jet reaction load calculations need to be reviewed prior to selecting proper equipment.

--------------------------------------

Common Options & Accessories

• Nozzles
  • Shaper Tips - For straight stream maximum reach
  • Fog Nozzle
    • Cable Operated - Operated from ground level via cables. Straight stream to fog spray.
    • Hydraulic - Operated from ground level via hydraulic pump. Straight stream to fog spray. Recommended for taller systems in non sub zero temperatures.
• Intake Bases - The structural interconnection between the elevated monitor & incoming piping system. (Required)
• Swivel Grease Kits - To allow for remote swivel greasing from ground level.
• Nozzle Handle Kits - For use with cable operated nozzles. (Required)
• Nozzle Cable Bracket Kits - Brackets to guide nozzle cables.
• Nozzle Gear Pump Kits- For use with hydraulic fog nozzles. (Required)
• Valves - For turning on the water to the system.